LED tail strobe :: DSCN2069
View Images: normal | [full] Photo properties (Accesskey 'p')
Login (Accesskey 'i')
Gallery: Pix navigate UP Album: Jeff Peterson LNC 360 navigate UP Album: LED tail strobe navigate UP (accesskey 'U')
Frame/heat sink to hold 6 LEDs. Opening angle is 11 degrees to fit inside rudder. LED holes set at 20 degree angle. Weighs 90 grams. Through the microscope Wired with teflon wire, Voltrex heat shrink. Heat shrink is bonded in with gel superglue. Lens is Lexan, 1 mm thick. Current is 1/2 amp, this is NAV mode. Will stobe 6 amps using a circuit made of a 4555 and a Vfet. Here I have added a 1 mm thick aluminum access panel/heat sink. I will cut this down to less than half this size since the lights run quite cool. attachement ear added, circuit installed. tail strobe schematic
First Photo (Accesskey 'F') Previous Photo (Accesskey 'P') 7 of 13 Next Photo (Accesskey 'N') Last Photo (Accesskey 'L')
Jump to:
TL
Current is 1/2 amp, this is NAV mode. Will stobe 6 amps using a circuit made of a 4555 and a Vfet.
BB

Current is 1/2 amp, this is NAV mode. Will stobe 6 amps using a circuit made of a 4555 and a Vfet.

[Add comment]

Frame/heat sink to hold 6 LEDs. Opening angle is 11 degrees to fit inside rudder. LED holes set at 20 degree angle. Weighs 90 grams. Through the microscope Wired with teflon wire, Voltrex heat shrink. Heat shrink is bonded in with gel superglue. Lens is Lexan, 1 mm thick. Current is 1/2 amp, this is NAV mode. Will stobe 6 amps using a circuit made of a 4555 and a Vfet. Here I have added a 1 mm thick aluminum access panel/heat sink. I will cut this down to less than half this size since the lights run quite cool. attachement ear added, circuit installed. tail strobe schematic
First Photo (Accesskey 'F') Previous Photo (Accesskey 'P') 7 of 13 Next Photo (Accesskey 'N') Last Photo (Accesskey 'L')
Jump to:
Gallery: Pix navigate UP Album: Jeff Peterson LNC 360 navigate UP Album: LED tail strobe navigate UP (accesskey 'U')
Powered by Jallery v1 RSS